EMF measurements are measurements of ambient (surrounding) electromagnetic fields that are performed using particular sensors or probes, such as EMF meters. These probes can be generally considered as

: Apr, 2021 | Report ID: MRI77331

Phase Noise is a measure of the spectral purity of a signal in an oscillator system. It quantifies the short-term random variation of the frequency of the signal, and is a product of thermal noise and

: Apr, 2021 | Report ID: MRI77330

A waveguide filter is an electronic filter that is constructed with waveguide technology. Waveguides are hollow metal tubes inside which an electromagnetic wave may be transmitted. Filters are devices

: Apr, 2021 | Report ID: MRI77329

RF over Fiber modules convert RF signals to optical signals and back. One unit has an optical transmitter which converts the signal from RF to Optical, and a second receiver unit converts the signal f

: Apr, 2021 | Report ID: MRI77328

RF Phase Shifters are used to change the transmission phase angle of an input signal. Ideally phase shifters provide an output signal with an equal amplitude to the input signal, any loss here will be

: Apr, 2021 | Report ID: MRI77327

An RF Isolator is a two port device that protects RF components in a system from excessive signal reflection. It is a non-reciprocal device that ensures that all the power is transmitted from port 1 t

: Apr, 2021 | Report ID: MRI77326

Impedance matching pads are resistive networks that can be used to match 2 devices with different nominal impedances. The resistive network used in these impedance matching pads has a 5.7db theoritica

: Apr, 2021 | Report ID: MRI77325

An oscillator that uses a Dielectric Resonator as the frequency determining element, to produce signals with excellent signal stability, high Q and very low micro-phonics is called as Dielectric Reson

: Apr, 2021 | Report ID: MRI77324

A Receiver Multicoupler is used to connect multiple radio receivers to a single antenna. It splits a single input signal that it receives from the antenna into multiple signals with high port-to-port

: Apr, 2021 | Report ID: MRI77323

Microwave backhaul refers to the transportation of traffic (voice, video and data) between distributed sites and a more centralised point of presence via a radio link. Operators can lease

: Apr, 2021 | Report ID: MRI77322

A Detector Logarithmic Video Amplifier (DLVA) consists of a detector followed by a logarithmic video amplifier (LVA). The detector converts the RF energy into a DC voltage which is then amplified by a

: Apr, 2021 | Report ID: MRI77321

An RF Circulator is a 3 Port ferromagnetic device used to regulate the signal flow within a circuit. It transmits an input signal in one direction – A signal that enters port 1 is transmitted to port

: Apr, 2021 | Report ID: MRI77320

Flexible twistable is sealed electrically via a friction joint. This construction has the best twistable performance of all flexguides. The Twistable waveguide will hold limited pressure, but relies o

: Apr, 2021 | Report ID: MRI77319

Radar is becoming an important automotive technology. Automotive radar systems are the primary sensor used in adaptive cruise control and are a critical sensor system in autonomous driving assistance

: Apr, 2021 | Report ID: MRI77318

A direct current (DC) block is a frequency filtering device used in coaxial antenna systems. The DC block allows the passage of radio frequency (RF) signals while blocking audio and DC frequency inter

: Apr, 2021 | Report ID: MRI77317